Survex"> Spud"> wxWidgets"> .svx"> .3d"> .err"> .pos"> --survey=SURVEY Only load the sub-survey SURVEY -e, --elevation select elevation -p, --plan select plan view -b, --bearing=BEARING set bearing -t, --tilt=TILT set tilt -s, --scale=SCALE set scale -n, --station-names display station names -c, --crosses display crosses at stations -B, --no-border turn off the solid border around the edge of the survey. Printing to dot-matrix and inkjet printers can be significantly faster without this border as the printhead usually doesn't need to move all the way to the edge of the paper. -C, --no-cutlines If a printout takes more than one page, alignment ticks are printed where the page corners need to be joined. By default dash lines are also drawn along internal edges to facilitate trimming down the page with scissors. If you have a guillotine, the alignment ticks are sufficient for trimming the page and this option allows you to turn off the dashed lines. -l, --no-legs turn off display of survey legs -S, --surface turn on display of surface survey legs. By default only underground survey legs are shown. -k, --skip-blanks don't output blank pages With this option pages which are blank (apart from alignment marks and borders) will not be printed. "> -o, --output=OUTPUT set output file "> --calibrate print out calibration page "> When you run the printer driver you will be asked if you want a plan or elevation (enter For a plan enter bearing up the page, in degrees, 0 indicating North at the top of the page (the default). For an elevation enter the angle of view (i.e. the compass bearing from which the scene is viewed), and angle of tilt, where 0 is horizontal, - is looking down from above, and + is looking up from below, so -90 is the same as plan view. For an extended elevation, no viewing angles are needed. You'll be told the scale needed to fit the plot on one page, and be asked what scale you want to use. The you're told how many pages this will take (and the arrangement of those pages (e.g. 6 pages (2x3)) and have the opportunity to print, quit, or change the scale (so you can repeat this process until you have a scale and number of pages you are happy with). You can then print all the pages, a range of pages, or any arbitrary list of pages and ranges (handy for when your printer mangles a page). "> The configuration file ">